Programming tool for Renesas M16C/20, M16C/62, M16C/80 and 740, 38000, M79, M38, and ST9 series of microcontrollers: Supported Device List. This tool allows programming of MCU via synchronous serial interface in circuit only. A target system is required.Flash memory stores the target program.PCprogram allows batch mode processing for use in automated test systems. ASCII command interface used to control Flasher without the use of a PC program.
Features
Small, compact housing
Easy to use windows program
Serial (in target) programming supported
Programming / Verifying / Read back supported
2MByte internal Flash memory to store target program
High speed programming: app. 17 sec for 256 kb in serial mode with 10 MHz M16C target for programming and verification
Can be used in a production environment
PC program allows batch mode processing for usage in automated test systems.
Once set up, Flasher can be controlled without the use of PC program
ASCII command interface to control Flasher without the use of PC program (Requires firmware version 1.84 or above)
AUSTRALIA
AUSTRIA
BELGIUM
BRAZIL
CANADA
CHINA
CZECH REPUBLIC
DENMARK
FINLAND
FRANCE
GERMANY
GREECE
HONGKONG
HUNGARY
INDIA
IRELAND
ISRAEL
ITALY
JAPAN
KOREA,REPUBLIC OF
LIECHTENSTEIN
LUXEMBOURG
MALAYSIA
MEXICO
NETHERLANDS
NEW ZEALAND
NORWAY
PHILIPPINES
POLAND
PORTUGAL
RUSSIAN FEDERATION
SINGAPORE
SLOVAKIA
SOUTHAFRICA
SPAIN
SWEDEN
SWITZERLAND
TAIWAN, PROVINCE OF CHINA
THAILAND
UNITED KINGDOM
Programming tool for Renesas M16C/20, M16C/62, M16C/80 and 740, 38000, M79, M38, and ST9 series of microcontrollers: Supported Device List. This tool allows programming of MCU via synchronous serial interface in circuit only. A target system is required.Flash memory stores the target program.PCprogram allows batch mode processing for use in automated test systems. ASCII command interface used to control Flasher without the use of a PC program.