The EVB9S08DZ60/128 evaluation board allow users to program and debug advance application code with expanded I/O functions, peripherals and large prototype areas. It can be used as a stand alone application or via its built-in USB-to-BDM interface.
EVB9S08DZ Products
EVB9S08DZ128
100-pin LQFP package
EVB9S08DZ60
64-pin LQFP package
Features
EVB9S08DZ128/60
Clock module, crystal oscillator, and connector for providing an external clock source
BDM connector
Four header connections with all MCU signals
12 V DC barrel input connector (2.1 mm)
Two banana input connectors (12 V DC and GND)
Power on/off switch
Built-in "USB to BDM Interface"
Reset push-button
Four additional push buttons
Two potentiometers
Eight dip-switches
Series of jumpers to connect/disconnect the above controls
Outputs section containing ten LEDS and relative jumpers
CAN section that has CAN connector with two CAN transceivers (high speed and single wire) with series of jumpers to select the CAN physical layer
LIN section with LIN connectors andh LIN enable jumper and a "WAKE" push button
RS-232 section with two RS-232 connectors
Serial settings section containing two jumpers to select which transceiver is connected to microcontroller´s shared TXD1 and RXD1 serial lines
