The STK525 Starter Kit is dedicated to the AT90USB microcontrollers. It supports JTAGICE mkII and AVRISP mkII via AVR Studio. It includes a number demonstration program with source and hex files. The parts can be directly programmed through the USB port with FLIP In-System Programming utility.
STK525 Starter Kit Features
AT90USBxxx TQFP device (2.7V<5.5V)
AVR Studio software interface (STK525 is supported by AVR Studio, version 4.12SP2 or higher)
USB software interface for Device Firmware Upgrade (DFU bootloader). ATMEL Flip, In System Programming Version 3 or Higher shall be used for Device Firmware Upgrade.
STK500 compatible
Power supply flagged by "VCC-ON" LED
ISP connector for on-chip ISP
JTAG connector
Serial interfaces:
1 USB full/low speed device/host interface
RS-232C ports with RTS/CTS handshake lines
On-board resources:
4+1-ways joystick
4 LEDs
temperature sensor
microphone
serial dataflash memory
On-board RESET button
On-board HWB button for force bootloader section execution at reset
