Embedded Artists´ LPC1788 Developer´s Kit lets you get up-and-running quickly with the LPC1788 OEM Board. The LPC1788 OEM Board is equipped with NXP´s Cortex-M3 based LPC1788 microcontroller suitable for a wide range of applications that requires advanced communication and high quality graphics.

The LPC1788 OEM Board is low cost and can be used for prototyping/development as well as for OEM production. Modifications for OEM applications can be done for high volume customers.

Specification

LPC1788 OEM Board Processor:        NXP´s Cortex-M3 LPC1788 microcontroller in BGA package
Program Flash: 128 MB NAND FLASH + 512 kB internal
Data Memory:   32 MB SDRAM + 96 KB internal
                         32- or 16-bit data bus to SDRAM
                         Note: The Developer´s Kit initially only offer the 32-bit databus version.
Ethernet:          100/10M Ethernet interface based on SMSC LAN8720 Ethernet PHY
Clock Crystals:
                         12.000 MHz crystal for CPU
                         32.768 kHz crystal for RTC
Dimensions:      66 x 48 mm
Power:              +3.3V powering
Connectors:      200 pos expansion connector (as defined in SODIMM standard), 0.6mm pitch
Other:
                         256 Kbit I2C E2PROM for storing non-volatile parameters
                         Buffered 32- or 16-bit databus

OEM Base Board Connectors and Interfaces    

• 200 pos, 0.6mm pitch SODIMM connector for OEM Board
• LCD expansion connector with control signals for touch screen interface
• Expansion connector with all OEM Board signals
• Ethernet connector (RJ45)
• CAN interface & connector (provision for second CAN interface, but not mounted)
• MMC/SD interface & connector
• USB1: OTG or Host interface & connector
• USB2: Device or Host interface & connector
• Provision for NXP JN5148 RF module (former Jennic) interface (RF module not included)
• Full modem RS232 (cannot be fully used on 32-bit databus OEM boards)
• RS422/485 interface & connector
• Provision for IrDA transceiver interface (transceiver not mounted)
• I2S audio codec (mic in, line in, line out, headphone out) SWD/JTAG connector
• Trace connector and pads for ETM connector

Power

• Power supply, either via USB or external 5V DC
• Optional coin cell battery for RTC and LED on ALARM output (coin cell not included)

Other

• OEM Board current measuring
• Parallel NOR flash on external memory bus
• 16-bit register and LEDs on external memory bus
• 5-key joystick
• 3-axis accelerometer (I2C connected)
• LM75 temperature sensor (I2C connected)
• 5 push-button keys (four via I2C and one on ISP-ENABLE)
• 9 LEDs (8 via I2C and one on ISP-ENABLE)
• Trimming potentiometer to analog input
• USB-to-serial bridge on UART #0 (FT232R) and ISP functionality
• Reset push-button and LED
• Speaker output on analog output from OEM Board, or from I2S audio codec
• 160x150 mm in size

Included in the Kit

• One LPC1788 OEM Board (EA-OEM-009)
• One OEM Base Board (EA-OEM-500)
• One USB cable, type A to mini-B
• Headset with microphone
• Serial number that gives you access to the support site for this product

Data Sheet

LPC1788 Developer's Kit