Language: English | Deutsch | 中国的       Change Country  
 

Tag-Connect Plug-of-Nails™ Cable for use with TI’s MSP-FET430 for all MSP430 family MCU’s. » TC2050-IDC-430

Order Number Distributor Stock    
TC2050-IDC-430 Digi-Key Corporation 0 ORDER QUOTE
 
Tag-Connect’s TC2050-IDC-430 cable is a special version of the TC2050-IDC Plug-of-Nails™ cable designed to be plugged directly into TI’s MSP-FET430 and is compatible with all MSP430 MCU’s. The cable is fitted with a spring-pin Tag-Connector that conveniently plugs directly into your PCB and terminates in a 14-pin 0.1” ribbon connector.
  • Plugs straight to your PCB - No mating connector or header required!
  • Requires only a tiny footprint of pads and locating holes in your PCB.
  • Footprint MUCH smaller than the standard 14-pin ribbon header.
  • Zero Cost Per Board!
  • High-Reliability Spring-Pins make a Secure Connection and are rated for over 100,000 operations
  • Footprint has no height and reduces the size and space requirements of your PCB.
  • Also available in space-saving “no-legs” version (TC2050-IDC-430-NL).

Tag-Connect cables provide a simple, reliable means of connecting Debuggers and Programmers or other test equipment to your PCB’s while lowering board costs and facilitating efficient production programming.

Tag-Connect uses a specially designed (Patent Pending) connector which eliminates the need for putting a programming header or other mating connector on every PCB. Instead, Tag-Connect uses tried and tested spring-pins rated for over 100,000 operations to make a secure connection to a special footprint pattern of pads and locating holes in your PCB.

The legged version footprint takes about the same board space as two or three SMT resistors which means you can locate the footprint right next to the MCU if desired.

This 10-conductor cable has a TC2050 Tag-Connector on one end and a standard 14-pin ribbon connector on the other and is wired specifically for use with the TI MSP-FET430 debugger (and compatible MSP430 debuggers).  It is compatible with all MSP430 MCU’s. See also TC2050-IDC-430 NL (no-legs) version with a tiny 0.03” footprint. Also, if your MSP430 device supports SPY-BI-WIRE, take a look at the SPY-BI-TAG adaptor with the even smaller footprint TC2030-MCP 6-pin cables. Datasheet available at www.Tag-Connect.com

 FET and PCB are for illustration only and are not included.