The interface to this display can be directly to an external 8-bit or 16-bit memory bus or it can just as well be an emulated GPIO bus from processors without external memory interface. A serial (SPI-like) interface is also present. A simple 2x20 pin list (2.54mm pitch) is used to interface the display.
Integrated display controller with embedded display RAM.
A small graphical library for the display, with basic drawing operations, can be downloaded from our support page after purchase of the display.

QVGA LCD Display

• 8-bit or 16-bit parallel interface. Only occupies 2 addresses (i.e., one address pin) or serial 8-bit (SPI-like) interface (max 10 MHz clock)
• Diagonal size: 3.2 inch
• Display technology: TFT
• Display mode: Transmissive
• No of pixels: 240xRGBx320 (QVGA size)
• Supply voltage: 2.5-3.3V
• White LED backlight, with PWM control
• View area: 48.6 x 64.8 mm
• Dot size: 0.2025 x 0.2025 mm
• Operating temperature: -20 to + 70 degrees Celsius
• No of colors: 262K (if 18-bit mode), 65k (if 16-bit mode)
• 2x20 pin list (100 mil spacing) is required to interface the module
• 93x83 mm module size

Supported Base Boards

• The OLED display can be used directly with any of the following Embedded Artists Base Boards:
• OEM Base Board Basic - included in the LPC2468 Developer´s Kit.
• LPC31xx Base Board - included in the LPC3131 and LPC3152 Developer´s Kits.

It is also simple to interface the display via simulated memory bus (via GPIO) or via a SPI interface from any of NXP´s LPC1000/LPC2000/LPC3000 series.

User Manual

3.2 inch QVGA Color LCD